Arrows For 50 Lb Recurve Bow: The Ultimate Guide

What spine arrow do I need for a 50 lb recurve?

Gold Tip’s spine chart recommends an arrow with a 500-spine rating, assuming the arrow carries a 100-grain point. Take that same 50-pound bow, but increase the arrow length to 30 inches, and the chart calls for a 400 spine.

What size arrows do I need for my recurve bow?

Example: Recurve Bow is marked 30lbs @ 28 ” on the bottom limb. Your arrow length when at full draw is 29″ . Then you will be pulling more than 30lbs when you pull the bow beyond 28″. Usually you can add 2lbs per inch of draw, so for 29″ draw that would be 32lbs.

How heavy should my recurve arrows be?

Dr. Ed Ashby recommends a much heavier setup for maximum performance, starting at 650 grains for deer-sized animals. For my personal setup, I found myself somewhere in the middle of those two trains of thought. I shoot 570 grain arrows from my 65-lb Mathews VXR with a 30-inch draw length.

What grain arrow for a 55 pound bow?

Shooting a Mathews Heli m at 29 inch draw. Shooting 319 fps. Rule of thumb has been 5 grains for every lb of draw weight so a min for me would be a 350 grain arrow.

What poundage for 500 spine arrows?

500 spine arrow should be shot for bows from 45 – 55ish depending on tip weight. I know some very good archers who shoot a 500 spine arrow with 300 grains out front on a 50ish pound bow.

What happens if your arrow spine is too stiff?

Shooting an arrow that is not stiff enough, or a group of arrows that vary in stiffness, will cause you to be less accurate. An under-spined arrow will veer right, while an arrow that is too stiff will favor slightly left.

How to select arrows for a recurve bow?

When choosing arrows for a recurve bow, the weight is related to the poundage of your bow. Lighter bows tend to work best with lighter arrows, and heavier bows work best with heavier arrows.

What arrows for a 60 recurve bow?

Also, we strongly recommend that you use an arrow with at least 5 grains of weight per pound or draw weight (if you are shooting a 60 lb. bow, you should use and arrow of not less than 300 grains). This includes your field point or broadhead.

Can you shoot normal arrows out of a recurve?

use regular arrows not premium and kill wolves with 2 shots . More power for the arrows you choose to shoot from it (you can use any arrow in any bow), a longer range, and a flatter trajectory.

Do heavier arrows hit harder?

Not only will a heavier arrow hit harder, but it will retain its energy better through the target. This is a big benefit that will lead to more pass-throughs on bigger animals. Heavy arrows will also quiet your bow down. This is due to the heavier arrow simply absorbing more energy on the shot.

Are 340 or 400 arrows heavier?

So the larger the number, the heavier and stiffer the arrow.

Are heavier arrows more forgiving?

With a lot of weight up front, the wind may cause the fletching end of the arrow to oscillate back and forth in flight. However, the point will not oscillate nearly as much and will move in a relatively straight line (horizontally speaking) to the target. Using a heavy point will also make the arrow more forgiving.

Is 50 lb draw weight enough?

Minimum Draw Weight Requirements Most of them have a minimum draw weight of around 40 lbs. Some states — like Alaska — actually have minimum draw weights set in place for specific species. For deer, they require 40 lbs; however, for bigger game like moose they require 50 lbs.

Is a 550 grain arrow too heavy?

The happy medium weight is a range of 550 to 600 grains. In my experience, arrows in this range will be the easiest to tune and will deliver moderately flat flight out to, say, 45 yards depending on bow speed. This is where speed becomes a factor.

What grain arrow for 40 lb recurve?

That should put me between 400-500 grains of total arrow weight, which from what I understand should be pretty good for a #40 recurve. (10-12 grains per pound).

What is the difference between 400 and 500 spine arrows?

The numbers refer to the spine of the arrow. The different spines refer to the stiffness, a 400 spine arrow is generally for bows 40-60 lbs. 350 spine is for bows roughly 55 – 75 lbs, and a 500 spine arrow is for bows roughly 30 – 50 lbs.

What spine arrows for a 45lb recurve?

For that reason, I would suggest a 500 spine arrow, like the Gold Tip 3555 or equivalent. You could start with a 150 grain tip, and if the arrow is too stiff, you could try a heavier tip or add supplemental weight behind the insert, which GT is designed to do.

What poundage do professional archers use?

What draw weight do most Olympic archers use? Olympic archers use recurve bows that draw an average of around 48.5 pounds for the men and 33 pounds for the women. A typical limb on the bow can tolerate a draw weight of 48 to 51 pounds.

How to choose an arrow spine for a recurve?

To choose an arrow spine you need three numbers, the actual peak draw weight of your bow, the tip weight you will be using, and the length of the arrow shaft. Using this information, go to the arrow manufacturers’ spine specifications and find an arrow spine chart.

What spine arrow for a 60 pound bow?

I shot 60 pounds at 28” draw length and 300 spine with 80 grain tips at 27.5” arrow length — they shot very well. I shot those same arrows at 50 pounds draw weight with 100 grain tips — they also shot well.

How can I test my arrow spine at home?

Traditionally, spine is measured by bracing your arrow shaft exactly 26 inches apart and suspending a 2 pound weight from the center. The distance that the shaft deflects when the weight is placed on it will tell you your arrow spine– you then match your spine to your bow draw weight.

What is the best arrow rest for a recurve bow?

Screw-In Rests Compared to the stick-on option, these types of arrow rests provide more solid arrow support and are more accurate. Screw-in rests make a good option for recurve archers looking for a perfect mix of affordability, improved accuracy, and adjustability.

How do I tell what size arrows I need?

A good rule of thumb is to add 1-2 inches to the shooter’s draw length to determine the appropriate arrow length. For example, if a shooter has a draw length of 28 inches, an arrow length of 29-30 inches would be appropriate.

What arrows do I need for 70 lb bow?

For our purposes, a lightweight arrow will be one that has a finished weight of between 5 and 6 ½ grains per pound of your bow’s maximum draw force. For example, a lightweight arrow for a 70-pound bow would have a finished weight (including broadhead) between 350 and 455 grains.

What spine arrows for 50 lb recurve?

In addition depends on what grain broadhead you want to shoot. I would try 500 or 400 spine with a 125 tip for starters and aluminum arrows to get started until you now what it likes, easton has a chart that will tell you the spine and the numbers. You can bare shaft tune to fit the bow but that is a whole new topic.

Is a 60 pound bow enough?

If you have an average draw length of 27 to 29 inches, any modern compound bow matched with a good arrow and set to 60 pounds will work just fine on whitetails, mule deer, pronghorns, and the like with whatever broadhead style you prefer, so long as your shot placement is good.

What size recurve bow is best?

If you’re shooting more than a 29″ draw, a 70″ bow is recommended. If you shoot more than a 27″ draw, it’s a 68″ bow. If you shoot more than a 25″ draw, it’s a 66″ bow.

How do I figure out what spine arrow I need?

To choose an arrow spine you need three numbers, the actual peak draw weight of your bow, the tip weight you will be using, and the length of the arrow shaft. Using this information, go to the arrow manufacturers’ spine specifications and find an arrow spine chart.

What spine arrows for a 45lb recurve?

For that reason, I would suggest a 500 spine arrow, like the Gold Tip 3555 or equivalent. You could start with a 150 grain tip, and if the arrow is too stiff, you could try a heavier tip or add supplemental weight behind the insert, which GT is designed to do.

What is the difference between 400 and 500 spine arrows?

The numbers refer to the spine of the arrow. The different spines refer to the stiffness, a 400 spine arrow is generally for bows 40-60 lbs. 350 spine is for bows roughly 55 – 75 lbs, and a 500 spine arrow is for bows roughly 30 – 50 lbs.

How much does a 340 spine arrow weigh?

If you chose a 340 spine, bare arrow would be 256 grains. If it were me and I wanted decent point weight, but not a super heavy arrow, I would use the 50 grain insert, 100 grain head and go shoot.

What size Arrow for a 50 pound recurve bow?

Can you use the same weight arrows for recurve bows?

How to choose a recurve bow?

How much should a recurve bow weigh?